The only time I’ve used Special VFR “in anger” goes back some 20 years, to a less-than-perfect day at a towered airport. I was set to depart the following day, on a mission to ferry a familiar airplane from one coast to the other. At the time, I hadn’t flown the airplane in a couple of years, however, and I wanted to knock out some bangs-and-goes in it to refresh my memory. But the weather wasn’t cooperating: visibility was just over two miles in haze, with maybe a 2000-foot overcast and calm winds. A bunch of VFR-only pilots wanting to go flying that day were in the lounge grumbling.
Checking in on the ground frequency with the current ATIS, the controller advised me the field was IFR and they didn’t have a clearance for me. “Say intentions.” I responded with a request for Special VFR (SVFR) to do some pattern work and was immediately cleared to taxi, request approved. As something of a “Poor Man’s IFR,” my sort of mission one of the challenges Special VFR was created to meet, and there are many others. But Special VFR also offers us the opportunity to fly ourselves into a corner.
WHAT IT IS
The International Civil Aviation Organization, ICAO, defines SVFR as, “A VFR flight cleared by air traffic control to operate within a control zone in meteorological conditions below VMC.” In other words, it’s a set of rules allowing us to fly VFR when weather conditions are reported as less than normally required for VFR. For fixed-wing aircraft in the U.S., SVFR minima are one-mile of visibility and clear of clouds. This obviously differs substantially from the “FAA standard” three miles and 1000 feet minimum requirements, which can create interesting regulatory dilemmas on their own. Rotorcraft have their own SVFR minima—the sidebar on page 19 goes into greater detail on helicopter SVFR.
One thing SVFR is not is an IFR clearance. Sure; it allows us to operate in less than visual conditions, but that’s about it. It doesn’t allow us to enter a cloud, for example, and conditions may be such that leaving the controlled airspace you’re already in can mean you’re operating in IMC without an appropriate clearance, possibly resulting in a FAR violation. More about that in a moment.
Typical uses of SVFR include the pattern work I engaged in, plus entry, exit and transition of controlled airspace. In those instances, SVFR allows us to access that airspace without a formal IFR clearance. Right away, that sentence should raise some alarms for you. The sidebar above summarizes the SVFR FAR while the one below highlights the takeaways from the FAA’s Aeronautical Information Manual’s discussion of SVFR.
SVFR GOTCHA I
Remember when I mentioned a moment ago that SVFR can put you in the situation of operating in IMC without a clearance? Try this on for size.
You’re trying to depart an airport like Ocala (Florida) International Airport-Jim Taylor Field, KOCF. The part-time air traffic control tower is operating, it’s daytime and the weather advertisers are offering two miles in haze under a 1200-foot ceiling with calm winds, which is a widespread condition for the area. That’s a perfect scenario for using SVFR to depart. Since you only need a mile of visibility while remaining clear of clouds under SVFR, you can request and receive an appropriate clearance. It’s also a perfect scenario for a FAR violation. Here’s why.
Suppose your destination is the nearby Marion County Airport (X35) in Dunnellon, Florida. Marion County has an RNAV (GPS) approach, coincidentally serving Runway 23, which basically points at Ocala, so you’re planning to take off on Ocala’s Runway 18, turning slightly right for the short hop to Marion County and flying a straight-in to Runway 23. Ocala’s tower clears you to depart their Delta at or below 1000 feet msl, or 910 feet agl. The sectional chart excerpt above shows the lay of the land (including some obstructions reaching as high as 420 feet msl).
The only problem with this plan is that it’ll dump you out into controlled airspace in instrument conditions without an appropriate clearance.
Look closely: The Ocala Class D airspace comprises a four nm radius around the airport. While there’s a Class E surface area charted to the south, you won’t be entering it on this short hop. Beyond Ocala’s Delta is Class E airspace, which the sectional chart’s magenta banding depicts as having a floor of 700 feet agl, to accommodate approaches into Ocala and Marion County. However, your SFVR clearance is only good for the Class D airspace; the Ocala tower’s jurisdiction ends four miles into your 10 nm hop. If you climb to the full 1000 feet msl as cleared by Ocala tower, you’ll be in Class E airspace until you descend to at least 789 feet msl, and 764 feet as you near Marion County. In any case, you’ll likely want to be at an altitude ensuring clearance from the adjacent antennas, just in case your navigation is off a bit. If you stayed at 1000 feet msl until sighting the runway at Marion County, congratulations, you just flew in controlled airspace when the weather was lower than VMC without an IFR clearance. No, it’s not likely there will be a fed waiting for you on the ramp at Marion County, but you never know.
SVFR GOTCHA 2
Another way SVFR can get you into a bind might be more familiar. Let’s say you’re at a different Class D airport and its weather also is below VFR minimums. But the conditions aren’t as widespread as in the preceding scenario at Ocala, and you know there is good VFR about 30 miles away, in the general direction of your route of flight. The local controllers are happy to give you an SVFR clearance to get you on your way. Should you take it?
This is where judgment and experience can pay big dividends. Presuming the terrain over which you’ll be flying for those 30 miles before reaching VMC is relatively flat and not peppered with obstructions, it might not be a bad idea. You can scoot along in reduced visibility or under a low cloud deck until the weather lifts, climb to a preferred cruising altitude and motor on to your destination.
For the first 30 miles or so, you’ll be scud running, with all the attendant additional risks, and SVFR is an open invitation to engage in it. The sidebar at the bottom of the opposite page highlights another gotcha in this scenario, involving FAR 91.119, Minimum safe altitudes, and FAR 91.155, Basic VFR weather minimums. Putting aside the CFIT and obstacle-collision risks associated with scud running, you easily can find yourself between a rock and a hard place when trying to comply with all the relevant regulations. Note that the graphic at the bottom of the opposite page is only usable over non-congested areas; over congested areas, you need to be 1000 feet above the highest obstacle within a horizontal radius of 2000 feet of the aircraft.
WHAT IS IT GOOD FOR?
Both of these scenarios might leave you to conclude SVFR is for idiots, and remove it from your bag of tools forever. And that might be good choice. But consider—in addition to doing pattern work at a Class D airport—a situation where there’s an outlying, non-towered airport inside a nearby airport’s Class C airspace. My favorite example is the Westport Airport (71K, known locally as Dead Cow International), a non-towered facility less than three nm from the Wichita (Kansas) Dwight D. Eisenhower National Airport (KICT), which is in Class C airspace. Again, the weather is less than required for VFR.
Arriving IFR, you shoot the ILS for Runway 1R into Wichita, perhaps descending only to the circling minima of 1800 feet (467 feet agl) and breaking out underneath the overcast. But you’re not based at KICT; your car is at Westport, for which there’s no published instrument approach. Your normal, good-weather plan is to cancel IFR and motor over to Westport under VFR and land. One way—perhaps the only way—to get to Westport in this weather is to work out with the tower at KICT that you’ll cancel IFR on breaking out and are requesting an SVFR clearance to proceed to 71K and land. That’s an admittedly extreme scenario, but the basic idea—shoot an approach into the larger airport, then cancel IFR and head off to your real destination—is tried and true.
Of course, there are many other scenarios out there that can allow us to make safe use of SVFR. But we need to be careful: Using SVFR easily can lead us into situations where a FAR bust or CFIT occurs, along with meeting some moron out there doing the same thing,
Related Posts
SVFR – What The FARS Say
Aim Guidance On SVFR
Helicopter SVFR
I have used SVFR many times at my old base and at LNS. Frequently things are fine but the airports are reporting 2 in haze with unlimited or fairly high ceilings. Due to their locations near water and mountains it is common that things are fine except at the airport itself. One time I was going up for a breakfast event to LNS. I listened the ATIS and it was 2 with unlimited ceilings. I got about 10 out and asked for SVFR in. The tower granted it and cleared me to land. After that a half a dozen planes asked for SVFR, they were waiting for the weather to improve. The tower was only allowing one at a time and cleared the next one after I landed. I could see LNS out about 5 miles but there was definitely a low level haze. Not 30 minutes later it was clear with unlimited ceilings. I got my breakfast while it was still fresh! I would not do this at an airport I am not familiar with.
Gotta hate the smog/haze in SoCal. I was a relatively new GA pilot. Took off out of El Toro to deliver an aero club bird to SNA for maintenance. Talk about expectations – on calling SNA tower, they said something completely unintelligible to me, turns out the field was IFR for visibility and I had no clue. The tower controller had to prompt me to say “request SVFR”. The only time I’ve ever used it.